Dog Bed Ramp – Ramps for dogs allow disabled, elderly or small dogs to climb up elevated areas. Dog owners often buy or build by their dogs so that dogs can climb up to the couch or bed to lie down. A ramp built for dogs should be gradual and easy to climb. Using horizontal plates spaced an inch apart for a ramp platform will make it easy for any dog to climb to an elevated area.
Draw a line from corner to corner on the 40-inch plywood and cut it in half with your circular saw so that you have two triangular pieces of equal size. You can use the rule to make sure your line is straight. These are the parts on your dog ramp. Position the sides of the dog ramp so they are resting on their edges of 40 inches, parallel, 17 inches apart and so the hypotenuses (longer sides) are aligned.
12 Picture Gallery: Dog Bed Ramp in DIY Ideas
Position five 17-inch boards perpendicularly between the edges of the ramp so that their 7 ½-inch surfaces are flush with the hypotenuses. Space 1 inch away from them. Screw through the sides of the ramp and into the ends of the 17-inch plates. Use four screws for each plate – two at each end. Adjust the last 17-inch table perpendicularly between the sides so it is on the edge, and flush with the edges of 20 inches. Screw through the sides of the ramp and into the 17-inch board with four screws.
This post topic: Bedding